Page No. : 6/9
Internal synchronized Slope Compensation
Built‐in slope compensation circuit adds voltage ramp onto the current sense input voltage for PWM generation.
This greatly improves the close loop stability at CCM and prevents the sub‐harmonic oscillation and thus reduces
the output ripple voltage.
Drive
The internal power MOSFET in RS2258 is driven by a dedicated gate driver for power switch control. Too weak the
gate driving strength results in higher conduction and switch loss of MOSFET while too strong gate drive results
the compromise of EMI.
A good tradeoff is achieved through the built‐in totem pole gate design with right output strength and dead time
control. The low idle loss and good EMI system design is easier to achieve with this dedicated control scheme.
In addition to the gate drive control scheme mentioned, the gate drive strength can also be adjusted externally by
a resistor connected between V
DD
and V
DDG
, the falling edge of the Drain output can be well controlled. It provides
great flexibility for system EMI design.
Protection Controls
Good power supply system reliability is achieved with its rich protection features including Cycle‐by‐Cycle current
limiting (OCP), Over Load Protection (OLP) and over voltage clamp, Under Voltage Lockout on VDD (UVLO).
With Orister Proprietary technology, the OCP is line voltage compensated to achieve constant output power limit
over the universal input voltage range.
At overload condition when FB input voltage exceeds power limit threshold value for more than T
D_PL
, control
circuit reacts to shut down the switcher. Switcher restarts when V
DD
voltage drops below UVLO limit.
V
DD
is supplied by transformer auxiliary winding output. It is clamped when V
DD
is higher than 30V. The output of
RS2258 is shut down when V
DD
drops below UVLO(ON) limit and Switcher enters power on start‐up sequence
thereafter.
DS‐RS2258‐09
May,
2010
www.Orister.com