Page No. : 11/13
TO‐220‐3 Dimension
NOTES:
A. All linear dimensions are in inches (millimeters).
B. This drawing is subject to change without notice.
C. Lead dimensions are not controlled within this area.
D. All lead dimensions apply before solder dip.
E. The center lead is in electrical contact with the tab.
F. The chamfer is optional.
G. Thermal pad contour optional within these dimensions.
H. Falls within JEDEC TO‐220 variation AB. Except minimum lead thickness, minimum exposed pad length, and maximum
body length.
DS‐RS1117A‐16 September, 2009
www.Orister.com