Plastic Infrared Emitting Diode
OP265WPS
Absolute Maximum Ratings
(T
A
= 25° C unless otherwise noted)
Storage and Operating Temperature Range
Reverse Voltage
Continuous Forward Current
Peak Forward Current (1 µs pulse width, 300 pps)
Lead Soldering Temperature [1/16 inch (1.6 mm) from case for 5 seconds with soldering iron]
Power Dissipation
-40
o
C to +100
o
C
2.0 V
50 mA
3.0 A
260° C
(1)
100 mW
(2)
Notes:
1. RMA flux is recommended. Duration can be extended to 10 second maximum when flow soldering. A maximum of 20 grams force
may be applied to the leads when soldering.
2. Derate linearly at 1.33 mW/° C above 25° C.
3. E
E(APT)
is a measurement of the average apertured radiant incidence upon a sensing area 0.081” (2.06 mm) in diameter, perpendicular
to and centered on the mechanical axis of the lens and 0.590” (14.99 mm) from the measurement surface. E
E(APT)
is not necessarily
uniform within the measured area.
Electrical Characteristics
(T
A
= 25° C unless otherwise noted)
SYMBOL
Input Diode
E
E (APT)
V
F
I
R
λ
P
B
Apertured Radiant Incidence
Forward Voltage
Reverse Current
Wavelength at Peak Emission
Spectral Bandwidth between Half Power
Points
2.70
-
-
-
-
-
-
-
850
-
-
1.80
20
-
-
mW/cm
2
I
F
= 20 mA
(3)
PARAMETER
MIN
TYP
MAX
UNITS
TEST CONDITIONS
V
µA
nm
nm
I
F
= 20 mA
V
R
= 2 V
I
F
= 10 mA
I
F
= 20 mA
OPTEK reserves the right to make changes at any time in order to improve design and to supply the best product possible.
Issue A
07/06
Page 2 of 3
OPTEK Technology Inc. —
1645 Wallace Drive, Carrollton, Texas 75006
Phone: (972) 323-2200 or (800) 341-4747
FAX: (972) 323-2396 sensors@optekinc.com www.optekinc.com
OPTEK [ OPTEK TECHNOLOGIES ]
