Applications
OV10625
¬
Automotive
- pedestrian detection
- lane-departure warning
- lane keeping assist
- blind spot detection
- traffic signal recognition
Ordering Information
¬
OV10625-N02V-1A-Z
(RCCC, lead-free, 102-pin aCSP™, rev 1A, in tray)
Product Features
¬
support for image size: WVGA, VGA,
QVGA and any cropped size
¬
¬
¬
supported output formats: RAW
horizontal and vertical sub-sampling
¬
¬
¬
¬
¬
high dynamic range
high sensitivity
Product Specifications
serial camera control bus (SCCB)
for register programming
¬
active array size: 752 x 548
¬
lens size:
- VGA: 1/3.7"
- WVGA: 1/3.2"
safety features
¬
external frame synchronization
capability
¬
power supply:
- core: 1.425 ~ 1.575V
- analog: 3.14 ~ 3.47V
- I/O: 1.7 ~ 3.47V
low power consumption
¬
¬
¬
lens chief ray angle: 9°
¬
¬
¬
¬
50/60 Hz flicker cancellation
parallel 16-bit DVP output
image sensor processor functions:
- automatic exposure/gain control
- lens correction
- defective pixel cancelation
- HDR combination and tone mapping
- automatic black level correction
input clock frequency: 6 ~ 27 MHz
¬
¬
power requirements:
- active: TBD
- standby: TBD
maximum image transfer rate:
60 fps full resolution
embedded temperature sensor
one time programmable (OTP) memory
temperature range:
¬
¬
¬
¬
¬
¬
¬
¬
dynamic range: ~120 dB
sensitivity: 15 V/lux-sec
scan mode: progressive
shutter: rolling shutter
- operating: -40°C to +105°C
sensor ambient temperature and
-40°C to +125°C junction temperature
(operating sensor junction
temperatures above +60°C
may result in degraded image quality)
¬
¬
output interfaces:
16-bit parallel DVP
maximum exposure interval: TBD
pixel size: 6 µm x 6 µm
output formats: up to 20-bit combined
RAW, separated 8-/10-bit RAW
image area: 4608 µm x 3384 µm
package dimensions:
- aCSP: 7310 µm x 7810 µm
Functional Block Diagram
OV10625
sensor core
image
processor
output
interface
column
sample
& hold
10-bit
ADC
+
AMP
+
ISP
-
-
D[15:0]
BLC
pixel
array
AEC
AGC
ADRC
control
register bank
temperature sensor
SPI master
interface
SCCB
interface
OSC
PLLs
timing generator and system control logic
OmniVision reserves the right to make changes to their products or to discontinue any product or
service without further notice. OmniVision and the OmniVision logo are registered trademarks of
OmniVision Technologies, Inc. OmniBSI is a trademark of OmniVision Technologies, Inc. All other
trademarks are the property of their respective owners.
4275 Burton Drive
Santa Clara, CA 95054
USA
Tel: + 1 408 567 3000
Fax: + 1 408 567 3001
www.ovt.com
Version 1.1, October, 2014