PEDL9204-02
OKI Semiconductor
ML9204-xx
Key matrix scan signal output pins.
Normally low level is output.
Key scanning starts by detecting depression or release
of key matrix switch and continues until selection of key
scan stop mode.
74 to 78
ROW1 to 5
O
Key matrix
When key scan stop mode is selected, all outputs of
ROW1 to 5 return to low level.
Reset input.
“Low” initializes all the functions.
Initial status is as follows.
• Address of each RAM..............address “00”H
• Data of each RAM ...................Content is undefined
• Display digit.............................24 digits
• Brightness adjustment .............0/1024
• All lights ON or OFF................OFF mode
• ROW1 to 5..............................becomes low level
• INT..........................................becomes low level
91
RESET
l
Micro controller
Pins for self-oscillation.
(Do not apply external clocks to these pins.)
Connect these pins to the crystal and capacitors or to
the ceramic resonator and capacitors.
The target oscillation frequency is 4.0MHz.
(The device has an internal feedback resister.)
72
73
OSC0
OSC1
l
Crystal or
ceramic
resonator
VDD
3.3V
5.0V
Typical
1Mohm
0.4Mohm
O
* For information regarding the oscillator contact the
manufacturer of the oscillator.
* As regards the circuit, refer to the Application Circuit.
5/41
OKI [ OKI ELECTRONIC COMPONETS ]
