IMP5111/5112
IMP5218
DATA
C
OMMUNICATIONS
Key Features
9-Line Plug and Play
SCSI Terminator
ꢀ
SCSI plug and play
— Dual disconnect pins
— Logic LOW disconnects lines
The 9-channel IMP5218 SCSI terminator is part of IMP's family of high-
performance SCSI terminators that deliver true UltraSCSI performance.
The BiCMOS design offers superior performance over first generation
linear regulator/ resistor based terminators.
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
Hot swap compatible
Ultra-Fast response for Fast-20 SCSI applications
35MHz channel bandwidth
The IMP5218 has two disconnect pins for SCSI Plug and Play (PnP)
applications.
3.5V operation
IMP's new architecture employs high-speed adaptive elements for each
channel, thereby providing the fastest response possible - typically
35MHz, which is 100 times faster than the older linear regulator termi-
nator approach. The bandwidth of terminators based on the older
regulator/ resistor terminator architecture is limited to 500kHz since a
large output stabilization capacitor is required. The IMP architecture
eliminates the external output compensation capacitor and the need
for transient output capacitors while maintaining pin compatibility
with first generation designs. Reduced component count is inherent
with the IMP5218.
Less than 3pF output capacitance
375µA disable-mode current
Thermally self limiting
No external compensation capacitors
Implements 8-bit or 16-bit (wide) applications
Compatible with active negation drivers
(60mA/ channel)
ꢀ
ꢀ
Compatible with passive and active terminations
Approved for use with SCSI 1, 2, 3 and UltraSCSI
The IMP5218 architecture tolerates marginal system designs. A key
improvement offered by the IMP5218 lies in its ability to insure reliable,
error-free communications even in systems which do not adhere to rec-
ommended SCSI hardware design guidelines, such as improper cable
lengths and impedance. Frequently, this situation is not controlled by the
peripheral or host designer.
For portable and configurable peripherals, the IMP5218 can be placed in
a sleep mode with two disconnect signals. When disabled, the quiescent
current is typically 375µA, and the outputs are in a high impedance state.
Block Diagrams
Term Power
24mA Current
Limiting Circuit
DATA OUTPUT
PIN DB (0)
Thermal
Limiting
Circuit
Current
Biasing
Circuit
2.85V
DISCONNECT 1
DISCONNECT 2
1 of 9 Channels
5218_01.eps
Daily Silver IMP
Data Communications
1
IMP [ IMP, INC ]
