TECHNICAL DATA
IN74ACT652
Octal 3-State Bus Transceivers
and D Flip-Flops
High-Speed Silicon-Gate CMOS
The IN74ACT652 is identical in pinout to the LS/ALS652,
HC/HCT652. The IN74ACT652 may be used as a level converter for
interfacing TTL or NMOS outputs to High Speed CMOS inputs.
These devices consists of bus transceiver circuits, D-type flip-flop,
and control circuitry arranged for multiplex transmission of data directly
from the data bus or from the internal storage registers. Direction and
Output Enable are provided to select the read-time or stored data function.
Data on the A or B Data bus, or both, can be stored in the internal D flip-
flops by low-to-high transitions at the appropriate clock pins (A-to-B
Clock or B-to-A Clock) regardless of the select or enable or enable
control pins. When A-to-B Source and B-to-A Source are in the real-time
transfer mode, it is also possible to store data without using the internal
D-type flip-flops by simultaneously enabling Direction and Output
Enable. In this configuration each output reinforces its input. Thus, when
all other data sources to the two sets of bus lines are at high impedance,
each set of bus lines will remain at its last state.
ORDERING INFORMATION
IN74ACT652N Plastic
IN74ACT652DW SOIC
TA = -40° to 85° C for all packages
The IN74ACT652 has noninverted outputs.
PIN ASSIGNMENT
•
•
•
•
•
TTL/NMOS Compatible Input Levels
Outputs Directly Interface to CMOS, NMOS, and TTL
Operating Voltage Range: 4.5 to 5.5 V
Low Input Current: 1.0 µA; 0.1 µA @ 25°C
Outputs Source/Sink 24 mA
LOGIC DIAGRAM
PIN 24=VCC
PIN 12 = GND
Rev. 00
IKSEMICON [ IK SEMICON CO., LTD ]
