Preliminary
PowerPC 405GPr Embedded Processor Data Sheet
Features
• IBM PowerPC 405 32-bit RISC processor core
operating up to 400MHz with 16KB I- and
D-caches
- Synchronous or asynchronous PCI Bus
interface
- Internal or external PCI Bus Arbiter
• PC-133 synchronous DRAM (SDRAM) interface
- 32-bit interface for non-ECC applications
• Ethernet 10/100Mbps (full-duplex) support with
media independent interface (MII)
• Programmable interrupt controller supports 13
external and 19 internal edge triggered or level-
sensitive interrupts
- 40-bit interface serves 32 bits of data plus 8
check bits for ECC applications
• 4KB on-chip memory (OCM)
• Programmable timers
• External peripheral bus
• Two serial ports (16550 compatible UART)
• One IIC interface
- Flash ROM/Boot ROM interface
- Direct support for 8-, 16-, or 32-bit SRAM
and external peripherals
• General purpose I/O (GPIO) available
• Supports JTAG for board level testing
- Up to eight devices
- External Mastering supported
• Internal processor local Bus (PLB) runs at
SDRAM interface frequency
• DMA support for external peripherals, internal
UART and memory
• Supports PowerPC processor boot from PCI
memory
- Scatter-gather chaining supported
- Four channels
• Unique software-accessible 64-bit chip ID
number (ECID).
• PCI Revision 2.2 compliant interface (32-bit, up
to 66MHz)
Description
Designed specifically to address embedded
applications, the PowerPC 405GPr (PPC405GPr)
provides a high-performance, low-power solution
that interfaces to a wide range of peripherals by
incorporating on-chip power management features
and lower power dissipation requirements.
support, serial ports, IIC interface, and general
purpose I/O.
Technology: IBM CMOS SA-27E, 0.18 µm
(0.11 µm Leff)
Package: 456-ball (35mm or 27mm) enhanced
plastic ball grid array (E-PBGA)
This chip contains a high-performance RISC
processor core, SDRAM controller, PCI bus
interface, Ethernet interface, control for external
ROM and peripherals, DMA with scatter-gather
Power (typical): 0.72W at 266MHz
While the information contained herein is believed to be accurate, such information is preliminary, and should not be
relied upon for accuracy or completeness, and no representations or warranties of accuracy or completeness are made.
Page 1 of 58
3/14/03