MP7523/XRD7523
ELECTRICAL CHARACTERISTICS (CON’T)
25°C
Typ
Tmin to Tmax
Parameter
Symbol
Min
Max
Min
Max
Units
Test Conditions/Comments
POWER SUPPLY
2
Functional Voltage Range
Supply Current
V
I
5
16
1.6
5
16
1.6 mA
V
DD
All digital inputs = 0 V or all = 15 V
DD
NOTES:
1
Full Scale Range (FSR) is 10V.
Guaranteed but not production tested.
Digital input levels should not go below ground or exceed the positive supply voltage, otherwise damage may occur.
Specified values guarantee functionality. Refer to other parameters for accuracy.
2
3
4
Specificationsare subject to change without notice
1, 2
ABSOLUTE MAXIMUM RATINGS (TA = +25°C unless otherwise noted)
V
DD
to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +17 V
Storage Temperature . . . . . . . . . . . . –65°C to +150°C
Digital Input Voltage to GND GND –0.5 to V +0.5 V
DD
Lead Temperature (Soldering, 10 seconds) . +300°C
I
, I
to GND . . . . . . . . . . . . . . . . . –0.5 to 6.5 V
to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +25 V
to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +25 V
OUT1 OUT2
Package Power Dissipation Rating to 75°C
V
V
REF
RFB
CDIP, PDIP, SOIC . . . . . . . . . . . . . . . . . . . . 800mW
Derates above 75°C . . . . . . . . . . . . . . . . . 11mW/°C
NOTES:
1
Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a
stress rating only and functional operation at or above this specification is not implied. Exposure to maximum rating
conditions for extended periods may affect device reliability.
2
Any input pin which can see a value outside the absolute maximum ratings should be protected by Schottky diode clamps
(HP5082-2835) from input pin to the supplies.
APPLICATION NOTES
Refer to Section 8 in the 1995 Data Acquisition Products databook for Applications Information
Rev. 3.00
4
EXAR [ EXAR CORPORATION ]
