EVERLIGHT ELECTRONICS CO.,LTD.
19-213/R7C-AQ1R2/3T
Precautions For Use
1. Over-current-proof
Customer must apply resistors for protection , otherwise slight voltage shift will cause big
current change ( Burn out will happen ).
2. Storage
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package, the LEDs should be kept at 30℃ or less and 90%RH or less.
2.3 After opening the package: The LED's floor life is 1 year under 30℃ or less and 60% RH or less.
If unused LEDs remain, it should be stored in moisture proof packages.
2.4 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the
storage time, baking treatment should be performed using the following conditions.
Baking treatment : 60±5℃ for 24 hours.
3. Soldering Condition
3.1 Pb-Free solder temperature profile
3.2 Reflow soldering should not be done more than two times.
3.3 When soldering, do not put stress on the LEDs during heating.
3.4 After soldering, do not warp the circuit board.
Everlight Electronics Co., Ltd.
http://www.everlight.com
Rev 1
Page: 9 of 10
Ver.:1 Release Date:09/19/2008 Confidential Level:一般 狀態:Approved(正式發行)
Prepared by :Qilong Chen
Device No:SZDSE-193-R38
Prepared date:24-Dec-2007
ꢀ
EVERLIGHT [ EVERLIGHT ELECTRONICS CO., LTD ]
