EVERLIGHT ELECTRONICS CO.,LTD.
17-215UBC/C430/TR8
within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do
soldering of each terminal. Be careful because the damage of the product is often started at the time of the
hand solder.
5.Repairing
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a
double-head soldering iron should be used (as below figure). It should be confirmed beforehand whether
the characteristics of the LEDs will or will not be damaged by repairing.
EVERLIGHT ELECTRONICS CO., LTD.
Office: No 25, Lane 76, Sec 3, Chung Yang Rd,
Tucheng, Taipei 236, Taiwan, R.O.C
Tel: 886-2-2267-2000, 2267-9936
Fax: 886-2267-6244, 2267-6189, 2267-6306
http://www.everlight.com
Everlight Electronics Co., Ltd.
Device No. : SZDSE-175-006
http://www.everlight.com
Prepared date: 07-27-2005
Rev.2
Page: 9 of 10
Prepared by: Aihua hong
EVERLIGHT [ EVERLIGHT ELECTRONICS CO., LTD ]
