欢迎访问ic37.com |
会员登录 免费注册
发布采购

EUP8080 参数 Datasheet PDF下载

EUP8080图片预览
型号: EUP8080
PDF下载: 下载PDF文件 查看货源
内容描述: 500毫安锂离子电池充电器,带有集成600mA同步降压转换器 [500mA Li-Ion Charger with Integrated 600mA Synchronous Buck Converter]
分类和应用: 转换器电池
文件页数/大小: 21 页 / 865 K
品牌: EUTECH [ EUTECH MICROELECTRONICS INC ]
 浏览型号EUP8080的Datasheet PDF文件第2页浏览型号EUP8080的Datasheet PDF文件第3页浏览型号EUP8080的Datasheet PDF文件第4页浏览型号EUP8080的Datasheet PDF文件第5页浏览型号EUP8080的Datasheet PDF文件第7页浏览型号EUP8080的Datasheet PDF文件第8页浏览型号EUP8080的Datasheet PDF文件第9页浏览型号EUP8080的Datasheet PDF文件第10页  
芯美 子  
Preliminary  
EUP8080  
Electrical Characteristics (TA = 25, VCC = 5V, VBAT = 3.8V,  
= 0V, VEN_BUCK = VBAT, VMODE = 0V.)  
VEN _ CHRG  
EUP8080  
Unit  
Symbol  
Parameter  
Conditions  
Min. Typ. Max.  
RON_P  
RON_N  
IPK  
PMOS Switch On-Resistance  
PMOS Switch On-Resistance  
Peak Inductor Current  
0.26  
0.28  
2.1  
A
Form the Rising Edge of  
EN_BUCK to 90% of Buck  
Regulated Output  
tSS_BUCK Buck Soft-Start Time  
Logic  
VIH  
120  
µs  
EN _ CHRG , EN_BUCK, MODE  
Pin Low to High  
Input High Voltage  
Input Low Voltage  
1.4  
V
V
EN _ CHRG , EN_BUCK, MODE  
Pin High to Low  
VIL  
0.4  
285  
90  
330  
135  
1
Output Low Voltage (  
Output Low Voltage (  
Input Current High  
)
)
CHRG  
ACPR  
VOL  
I
SINK = 5mA  
mV  
EN_BUCK, MODE Pins at 5.5V,  
BAT = 5V  
IIH  
IIL  
-1  
-1  
µA  
µA  
V
EN _ CHRG , EN_BUCK, MODE  
Pins at GND  
Input Current Low  
1
= 1V, Internal Pull Low  
VEN _ CHRG  
REN _ CHRG  
8
M  
EN _ CHRG Pin Input Resistance  
Current=130nA  
VBAT = 4.5V,  
= 5V  
1
1
ICHRG  
IACPR  
VCHRG  
µA  
µA  
Pin Leakage Current  
Pin Leakage Current  
CHRG  
ACPR  
VCC = 3V,  
= 5V  
VCHRG  
Note 1: Stresses beyond those listed under Absolute  
Maximum Ratings may cause permanent damage to the  
device. Exposure to any Absolute Maximum Rating  
condition for extended periods may affect device  
reliability and lifetime.  
Note 5: The 2.6V maximum buck undervoltage lockout  
(VUVLO_BUCK) exit threshold must first be exceeded  
before the minimum VBAT specification applies.  
Note 6: IC/10 is expressed as a fraction of measured full  
charge current with indicated PROG resistor.  
Note 2: The EUP8080 is guaranteed to meet  
performance specifications form 0to 85.  
Specifications over the -40to 85operating  
temperature  
range  
are  
assured  
by  
design,  
characterization and correlation with statistical process  
controls.  
Note 3: Failure to solder the exposed backside of the  
package to the PC board ground plane will result in a  
thermal resistance much higher than 43/W.  
Note 4: Although the EUP8080 charger functions  
properly at 3.75V, full charge current requires an input  
voltage greater then the desired final battery voltage per  
VUVCL1 specification.  
DS8080 Ver 0.1 Aug. 2007  
6
:15999644579 83151715