EtronTech
EM636165
1M x 16 SDRAM
The read data appears on the DQs subject to the values on the LDQM/UDQM inputs two clocks
earlier (i.e. LDQM/UDQM latency is two clocks for output buffers). A read burst without the auto
precharge function may be interrupted by a subsequent Read or Write command to the same bank
or the other active bank before the end of the burst length. It may be interrupted by a
BankPrecharge/ PrechargeAll command to the same bank too. The interrupt coming from the Read
command can occur on any clock cycle following a previous Read command (refer to the following
figure).
T0
T1
T2
T3
T4
T5
T6
T7
T8
CLK
COMMAND
READ A
READ B
DOUT A
NOP
NOP
NOP
NOP
NOP
NOP
NOP
CAS# latency=1
DOUT B
DOUT B
DOUT B
DOUT B
3
0
0
1
2
t
, DQ's
CK1
CAS# latency=2
, DQ's
DOUT A
DOUT B
DOUT B
DOUT B
2
DOUT B
DOUT B
0
0
1
3
t
CK2
CAS# latency=3
, DQ's
DOUT A
DOUT B
DOUT B
DOUT B
3
0
0
1
2
t
CK3
Read Interrupted by a Read
(Burst Length = 4, CAS# Latency = 1, 2, 3)
The LDQM/UDQM inputs are used to avoid I/O contention on the DQ pins when the interrupt
comes from a Write command. The LDQM/UDQM must be asserted (HIGH) at least two clocks prior
to the Write command to suppress data-out on the DQ pins. To guarantee the DQ pins against I/O
contention, a single cycle with high-impedance on the DQ pins must occur between the last read
data and the Write command (refer to the following three figures). If the data output of the burst
read occurs at the second clock of the burst write, the LDQM/UDQM must be asserted (HIGH) at
least one clock prior to the Write command to avoid internal bus contention.
T0
T1
T2
T3
T4
T5
T6
T7
T8
CLK
DQM
COMMAND
DQ's
NOP
READ A
NOP
NOP
NOP
NOP
WRITE B
DINB
NOP
NOP
DOUT A
0
DINB
DINB
2
0
1
Must be Hi-Z before
the Write Command
: "H" or "L"
Read to Write Interval
(Burst Length 4, CAS# Latency = 3)
Preliminary
8
Rev. 2.7 Mar. 2006
ETRON [ ETRON TECHNOLOGY, INC. ]
