Film Capacitors – Power Electronic Capacitors
MKP DC
B2562*
Construction and general data
Characteristics
Standard capacitance tolerance
Dielectric dissipation factor (tan δo)
Θstg
K: ±10%
2 • 10-4
–55 ... +85 °C
Expected lifetime tLD (co)
100 000 h at Θhs +75°C (refer to section 1)
200 (refer to section 2)
–55 °C
Fit rate
Minimum temperature Θmin.
Maximum temperature Θmax.
Storage temperature Θstg
Maximum hotspot temperature Θhs
(refer to section 1)
+ 70 °C (refer to section 2)
–55 ... +85 °C
+85 ºC for diameter 85 and 90 mm
+75 °C for diameter 116 mm
55/70/56
Climatic category
Maximum altitude
2000 m above sea level
(derating curves available upon request)
Test data
Voltage between terminals VTT
Voltage between terminals and case VTC
Dissipation factor tan δ (100 Hz)
Life test
1.5
VDC , 10s
4000 VAC, 10s
≤ 1.0 • 10-3
According to IEC 61071
Naturally air-cooled (or forced air cooling)
Indoor mounting
Cooling
Degree of protection
Design data
Impregnation
Resin filling: Non PCB, hard polyurethane (dry type)
Mounting and grounding
Max. torque (case) M12 stud
Max. torque terminal
M12 threaded bolt on bottom of the aluminum case
10 Nm
Female M6: 5 Nm
Female M8: 6 Nm
Male M8: 8 Nm
Reference standards
IEC 61071
RoHS compliance
Certification: UL 810-5th edition (refer to table 1.3)
FILM R&D / FILM P PM
January 2013 – Version 8
Please read Cautions and warnings and
Page 2 of 20
Important notes at the end of this document.
EPCOS [ EPCOS ]
