EM39LV088
8M Bits (1Mx8) Flash Memory
SPECIFICATION
Software Command Sequence
1st Bus
2nd Bus
3rd Bus
4th Bus
5th Bus
6th Bus
Command
Sequence
Write Cycle Write Cycle Write Cycle Write Cycle Write Cycle Write Cycle
Addr1 Data2 Addr1 Data2 Addr1 Data2 Addr1 Data2 Addr1 Data2 Addr1 Data2
Byte Program
Sector Erase
Block Erase
Chip Erase
AAAH AAH
AAAH AAH
AAAH AAH
AAAH AAH
555H
555H
555H
555H
55H AAAH A0H
WA3
Data
4
4
55H AAAH 80H AAAH AAH
55H AAAH 80H AAAH AAH
55H AAAH 80H AAAH AAH
555H
555H
555H
55H
55H
SAX
BAX
30H
50H
55H AAAH 10H
Software ID
Entry5,6
AAAH AAH
555H
55H AAAH 90H
Manufacture ID
Manufacture ID
Manufacture ID
Device ID
AAAH AAH
AAAH AAH
AAAH AAH
AAAH AAH
555H
555H
555H
555H
55H AAAH 90H
55H AAAH 90H
55H AAAH 90H
55H AAAH 90H
00H
07H
80H
01H
7FH
7FH
01FH
21FH
Software ID Exit7 XXH
F0H
Software ID Exit7 AAAH AAH
555H
55H AAAH F0H
Notes:
1. Address format A14-A0 (Hex), Addresses A19-A15 can be VIL or VIH, but no other value, for the Command
sequence.
2. DQ7-DQ0 can be VIL or VIH, but no other value, for the Command sequence.
3. WA = Program byte address.
4. SAX for Sector-Erase; uses A19-A12 address lines.
BAX for Block-Erase; uses A18-A16 address lines.
5. The device does not remain in Software Product ID mode if powered down.
6. Both Software ID Exit operations are equivalent.
7. Refer to Figure 9 for more information.
Table 3: Software Command Sequence
This specification is subject to change without further notice. (04.09.2004 V1.0)
Page 7 of 22