GD25Q128CxIGx 3.3V Uniform Sector Dual and Quad Serial Flash
http://www.elm-tech.com
1. FEATURES
128M-bit Serial Flash
Program/Erase Speed
♦
♦
- 16384K-byte
- Page Program time: 0.6ms typical
- Sector Erase time: 50ms typical
- Block Erase time: 0.2/0.3s typical
- Chip Erase time: 60s typical
- 256 bytes per programmable page
Standard, Dual, Quad SPI
♦
- Standard SPI: SCLK, CS#, SI, SO, WP#, HOLD#/RESET#
- Dual SPI: SCLK, CS#, IO0, IO1, WP#, HOLD#/RESET#
- Quad SPI: SCLK, CS#, IO0, IO1, IO2, IO3
- QPI: SCLK, CS#, IO0, IO1, IO2, IO3
Flexible Architecture
♦
♦
- Sector of 4K-byte
- Block of 32/64K-byte
High Speed Clock Frequency
Low Power Consumption
♦
♦
- 104MHz for Standard and Dual SPI fast read with 30PF load
- 20mA maximum active current
- 80MHz for Quad SPI and QPI fast read with 30PF load - 5μA maximum power down current
- Dual I/O Data transfer up to 208Mbits/s
Advanced Security Features(1)
♦
- Quad I/O Data transfer up to 320Mbits/s
- QPI Mode Data transfer up to 320Mbits/s
- Continuous Read With 8/16/32/64-byte Wrap
- 3×512-Byte Security Registers With OTP Locks
- Discoverable parameters(SFDP) register
Single Power Supply Voltage
- Full voltage range: 2.7~3.6V
♦
Software/Hardware Write Protection
- Write protect all/portion of memory via software
- Enable/Disable protection with WP# pin
- Top or Bottom, Sector or Block selection
Information
♦ Package
- SOP8 (208mil)
Cycling endurance
♦
♦
- WSON8 (6×5mm)
-
Minimum 100,000 Program/Erase Cycles
Data retention
-
20-year data retention typical.
Note: (1) Please contact ELM for details.
Rev.1.2
69 - 4
ELM [ ELM ELECTRONICS ]
