欢迎访问ic37.com |
会员登录 免费注册
发布采购

ELM327LSM 参数 Datasheet PDF下载

ELM327LSM图片预览
型号: ELM327LSM
PDF下载: 下载PDF文件 查看货源
内容描述: [Automatically searches for protocols]
分类和应用:
文件页数/大小: 94 页 / 471 K
品牌: ELM [ ELM ELECTRONICS ]
 浏览型号ELM327LSM的Datasheet PDF文件第3页浏览型号ELM327LSM的Datasheet PDF文件第4页浏览型号ELM327LSM的Datasheet PDF文件第5页浏览型号ELM327LSM的Datasheet PDF文件第6页浏览型号ELM327LSM的Datasheet PDF文件第8页浏览型号ELM327LSM的Datasheet PDF文件第9页浏览型号ELM327LSM的Datasheet PDF文件第10页浏览型号ELM327LSM的Datasheet PDF文件第11页  
ELM327L  
ELM327L Absolute Maximum Ratings  
Storage Temperature....................... -65°C to +150°C  
Note:  
These values are given as a design guideline only.  
The ability to operate to these levels is neither  
inferred nor recommended, and stresses beyond  
those listed here will likely damage the device.  
Ambient Temperature with  
Power Applied....................................-40°C to +85°C  
Voltage on VDD with respect to VSS..... -0.3V to +7.5V  
Voltage on any other pin with  
respect to VSS........................... -0.3V to (VDD + 0.3V)  
Current through pins 3 or 4  
(source or sink)...................................................2 mA  
Current through all other output pins  
(source or sink).................................................25 mA  
ELM327L Electrical Characteristics  
All values are for operation at 25°C. For more information, refer to note 1 below.  
Characteristic  
Minimum Typical Maximum Units  
Conditions  
Supply voltage, VDD  
2.0  
0.05  
1.7  
5.5  
V
see note 2  
VDD rate of rise  
V/msec  
V
Brown-out reset voltage  
A/D conversion time  
Pin 18 wake pulse duration  
IgnMon debounce time  
1.8  
7
1.9  
AT RV to beginning of response  
msec  
128  
50  
µsec to wake from Low Power mode  
msec  
65  
AT LP to PwrCtrl output time  
1.0  
2.0  
sec  
sec  
LP ALERT to PwrCtrl output time  
Measured from the end of the  
command to the start of the ID  
message (ELM327 v2.1)  
Reset time  
AT Z  
AT WS  
800  
2
msec  
msec  
continued on the next page…  
Notes:  
1. This integrated circuit is based on Microchip Technology Inc.’s PIC18F25K80 device. For more detailed  
device specifications, and possibly clarification of those given, please refer to the Microchip documentation  
(available at www.microchip.com).  
2. This spec must be met in order to ensure that a correct power on reset occurs. It is quite easily achieved  
using most common types of supplies, but may be violated if one uses a slowly varying supply voltage, as  
may be obtained through direct connection to solar cells or some charge pump circuits.  
ELM327L DSA  
Elm Electronics – Circuits for the Hobbyist  
7 of 94  
www.elmelectronics.com