MICROWAVE
A Division of Crystek Corporation
1.1 Trim Cable as shown.
Step 1
Step 2
Step 3
2.1 Slide clamp nut over cable as shown.
2.2 Solder cable to solder ferrule with dielectric flush with face of ferrule.
2.3 Slide dielectric stop (Ø 0.200 OD) over cable center conductor and solder contact flush to
stop to dimension shown.
2.4 Slide forward insulator and dielectric bead (Ø 0.173 OD) onto contact.
NOTE: Distance from end of cable center
conductor to Ref. Pl. is 0.325 (Ref)
3.1 Insert cable/contact sub-assembly into connector until seated and tighten clamp nut to
25-35 in-lbs.
Product Control:
Crystek Part Number:
Revision Level:
CS-SF-MSC
A
Release Date:
Responsible:
04-Jan-11
K. Piotrowicz
Page 2 of 2
12730 Commonwealth Drive • Fort Myers, Florida 33913
Phone: 239-561-3311 • 800-237-3061
CRYSTEK
CORPORATION
Fax: 239-561-1025 • www.crystek.com