MICROWAVE
A Division of Crystek Corporation
1.1 Trim Cable as shown.
Step 1
2.1 Slide clamp nut over cable as shown.
2.2 Insert cable into solder ferrule until cable dielectric is flush with face of ferrule.
2.3 Solder both cable braids where shown.
2.4 Slide dielectric stop over cable center conductor and solder contact flush against stop to
dimension shown.
Step 2
3.1 Insert forward insulator into connector in orientation shown.
3.2 Insert cable/contact sub-assembly into connector until seated and tighten clamp nut to
35-45 in-lbs.
Step 3
Product Control:
Crystek Part Number:
Revision Level:
CS-NM-MHB
A
Release Date:
Responsible:
04-Jan-11
K. Piotrowicz
Page 2 of 2
12730 Commonwealth Drive • Fort Myers, Florida 33913
Phone: 239-561-3311 • 800-237-3061
CRYSTEK
CORPORATION
Fax: 239-561-1025 • www.crystek.com
CRYSTEKMICROWAVE [ CRYSTEK CORPORATION ]
