MICROWAVE
A Division of Crystek Corporation
1.1 Trim Cable as shown.
Step 1
2.1 Slide clamp nut over cable as shown.
2.2 Insert cable into solder ferrule as shown then solder braids to ferrule where indicated.
2.3 Trim exposed cable dielectric flush with solder ferrule face.
2.4 Slide dielectric stop over cable center conductor and solder contact flush against stop to
dimension shown.
Step 2
3.1 Insert cable/contact sub-assembly into connector until seated
3.2 Tighten connector coupling nut to mating type N jack.
3.3 Tighten rear clamp nut to 30-40 in-lbs and disengage main interface from jack.
Step 3
Product Control:
Crystek Part Number:
Revision Level:
CS-NM-MHA
A
Release Date:
Responsible:
04-Jan-11
K. Piotrowicz
Page 2 of 2
12730 Commonwealth Drive • Fort Myers, Florida 33913
Phone: 239-561-3311 • 800-237-3061
CRYSTEK
CORPORATION
Fax: 239-561-1025 • www.crystek.com
CRYSTEKMICROWAVE [ CRYSTEK CORPORATION ]
