MICROWAVE
A Division of Crystek Corporation
1.1 Trim cable to expose dielectric core as shown.
1.2 Pre-tin cable jacket to approximate dimension shown.
Step 1
2.1 Slide clamp nut onto cable in orientation shown.
2.2 Insert cable into solder ferrule until fully seated, then solder cable to ferrule where shown.
2.3 Trim cable dielectric flush with ferrule face (do not score center conductor), then point center
conductor as shown.
Step 2
NOTE: Distance from end of cable
center conductor to Ref. Pl. is 0.279
3.1 Insert cable sub-assembly into connector body until solder ferrule is seated and tighten
clamp nut to 25-35 in. lbs.
Step 3
Product Control:
Crystek Part Number:
Revision Level:
CS-FM-MSR
C
Release Date:
Responsible:
18-Jul-11
K. Piotrowicz
Page 2 of 2
12730 Commonwealth Drive • Fort Myers, Florida 33913
Phone: 239-561-3311 • 800-237-3061
CRYSTEK
CORPORATION
Fax: 239-561-1025 • www.crystek.com
CRYSTEKMICROWAVE [ CRYSTEK CORPORATION ]
