MICROWAVE
A Division of Crystek Corporation
1.1 Trim Cable as shown.
Step 1
2.1 Install O-ring onto clamp nut where shown and slide clamp nut over cable in orientation
shown.
2.2 Insert cable into solder ferrule until seated and solder to cable braids where shown.
Step 2
3.1 Trim dielectric flush with seating surface of solder ferrule.
3.2 Verify center conductor dimension shown from ferrule seating surface.
Step 3
Page 2 of 3
12730 Commonwealth Drive • Fort Myers, Florida 33913
CRYSTEK
Phone: 239-561-3311 • 800-237-3061
CORPORATION
Fax: 239-561-1025 • www.crystek.com