Maximum Ratings at TA = 25°CNotes 1&3
DCꢀForwardꢀCurrent
CxxxTR260-Sxx00
50ꢀmA
PeakꢀForwardꢀCurrentꢀ(1/10ꢀdutyꢀcycleꢀ@ꢀ1ꢀkHz)
LEDꢀJunctionꢀTemperature
100ꢀmA
125°C
ReverseꢀVoltage
5ꢀV
OperatingꢀTemperatureꢀRange
-40°Cꢀtoꢀ+100°C
-40°Cꢀtoꢀ+120°C
≤30°Cꢀ/ꢀ≤85%ꢀRH
1000ꢀV
LEDꢀChipꢀStorageꢀTemperatureꢀRange
DieꢀSheetꢀStorageꢀConditions
ElectrostaticꢀDischargeꢀThresholdꢀ(HBM)ꢀNoteꢀ2
ElectrostaticꢀDischargeꢀClassificationꢀ(MIL-STD-883E)ꢀNoteꢀ2
Classꢀ2
Note 3
Typical Electrical/Optical Characteristics at TA = 25°C, If = 20 mA
Reverse Current
[I(Vr=5V), μA]
Full Width Half Max
Part Number
Forward Voltage (Vf, V)
(λD, nm)
Min.
Typ.
3.1
3.1
3.1
3.2
Max.
Max.
Typ.
20
C450TR260-Sxx00
C460TR260-Sxx00
C470TR260-Sxx00
C527TR260-Sxx00
2.7
2.7
2.7
2.9
3.4
3.4
3.4
3.6
2
2
2
2
21
21
35
Mechanical Specifications
Description
CxxxTR260-Sxx00
Dimension
Tolerance
±35
P-NꢀJunctionꢀAreaꢀ(μm)
ChipꢀAreaꢀ(μm)
220ꢀxꢀ440
260ꢀxꢀ480
115
±35
ChipꢀThicknessꢀ(μm)
±15
AuꢀBondꢀPadꢀDiameterꢀAnodeꢀ(μm)
AuꢀBondꢀPadꢀThicknessesꢀ(μm)
AuꢀBondꢀPadꢀAreaꢀCathodeꢀ(μm)
BottomꢀAreaꢀꢀ(μm)
90
-5,ꢀ+15
±0.5
1.0
98ꢀxꢀ98
160ꢀxꢀ380
-5,ꢀ+15
±35
Notes:
1.ꢀ Maximumꢀratingsꢀareꢀpackageꢀdependent.ꢀTheꢀaboveꢀratingsꢀwereꢀdeterminedꢀusingꢀaꢀT-1ꢀ3/4ꢀpackageꢀ(withꢀHysolꢀOS4000ꢀepoxyꢀ
encapsulationꢀandꢀclearꢀepoxyꢀdieꢀattach)ꢀforꢀcharacterization.ꢀRatingsꢀforꢀotherꢀpackagesꢀmayꢀdiffer.ꢀTheꢀforwardꢀcurrentsꢀ(DCꢀ
andꢀPeak)ꢀareꢀnotꢀlimitedꢀbyꢀtheꢀdieꢀbutꢀbyꢀtheꢀeffectꢀofꢀtheꢀLEDꢀjunctionꢀtemperatureꢀonꢀtheꢀpackage.ꢀTheꢀjunctionꢀtemperatureꢀ
limitꢀofꢀ125°CꢀisꢀaꢀlimitꢀofꢀtheꢀT-1ꢀ3/4ꢀpackage;ꢀjunctionꢀtemperatureꢀshouldꢀbeꢀcharacterizedꢀinꢀaꢀspecificꢀpackageꢀtoꢀdetermineꢀ
limitations.ꢀAssemblyꢀprocessingꢀtemperatureꢀmustꢀnotꢀexceedꢀ325°Cꢀ(<ꢀ5ꢀseconds).
2.ꢀ Productꢀresistanceꢀtoꢀelectrostaticꢀdischargeꢀ(ESD)ꢀaccordingꢀtoꢀtheꢀHBMꢀisꢀmeasuredꢀbyꢀsimulatingꢀESDꢀusingꢀaꢀrapidꢀavalancheꢀ
energyꢀtestꢀ(RAET).ꢀTheꢀRAETꢀproceduresꢀareꢀdesignedꢀtoꢀapproximateꢀtheꢀmaximumꢀESDꢀratingsꢀshown.ꢀTheꢀRAETꢀprocedureꢀisꢀ
performedꢀonꢀeachꢀdie.ꢀTheꢀESDꢀclassificationꢀofꢀClassꢀ2ꢀisꢀbasedꢀonꢀsampleꢀtestingꢀaccordingꢀtoꢀMIL-STD-883E.
3.ꢀ Allꢀproductsꢀconformꢀtoꢀtheꢀlistedꢀminimumꢀandꢀmaximumꢀspecificationsꢀforꢀelectricalꢀandꢀopticalꢀcharacteristicsꢀwhenꢀassembledꢀ
andꢀoperatedꢀatꢀ20ꢀmAꢀwithinꢀtheꢀmaximumꢀratingsꢀshownꢀabove.ꢀEfficiencyꢀdecreasesꢀatꢀhigherꢀcurrents.ꢀTypicalꢀvaluesꢀgivenꢀ
areꢀwithinꢀtheꢀrangeꢀofꢀaverageꢀvaluesꢀexpectedꢀbyꢀtheꢀmanufacturerꢀinꢀlargeꢀquantitiesꢀandꢀareꢀprovidedꢀforꢀinformationꢀonly.ꢀAllꢀ
measurementsꢀwereꢀmadeꢀusingꢀlampsꢀinꢀT-1ꢀ3/4ꢀpackagesꢀ(withꢀHysolꢀOS4000ꢀepoxyꢀencapsulantꢀandꢀclearꢀepoxyꢀdieꢀattach).ꢀ
OpticalꢀcharacteristicsꢀareꢀmeasuredꢀinꢀanꢀintegratingꢀsphereꢀusingꢀIlluminanceꢀE.
4.ꢀ Specificationsꢀareꢀsubjectꢀtoꢀchangeꢀwithoutꢀnotice.
Cree, Inc.
4600 Silicon Drive
Copyright © 2007-2011 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree
and the Cree logo are registered trademarks, and TR and TR260 are trademarks of Cree, Inc.
Durham, NC 27703
USA Tel: +1.919.313.5300
www.cree.com
2
CPR3DK Rev C