8/9
SPECIFICATIONS
Precautions
1. Avoid the application of any stress to the lens portion.
2. Avoid any contact by a sharp metal nail or other materials with the lens portion.
Lens portion
3. This product should be secured firmly by fastening an M3 screw on both sides of the product.
Please be careful not to apply any stress to the product during the clamping operation.
As the connection status could vary depending on materials of outer heat sink,
please check thoroughly.
Recommended torque:0.6~0.8Nm
(Insulation paste)
4. Thermal conductive silicone grease should be applied to the whole rear surface so that this product
can dissipate heat as a whole. However, the use of insulating paste is strongly recommended in
order to avoid short circuit. This product could be bent during the clamping operation if heat
grease in sheet form is used. For this reason, it is recommended that grease in paste form is used.
5. Handling of static electricity
- These products are sensitive to static electricity charge.
Please take measures to prevent any static electricity being produced such as the wearing of a
wristband or anti-static gloves when handling this product.
- All devices, equipment and machinery must be properly grounded. It is recommended that precautions
CE's lighting inspection criterion
be taken against s
- When inspecting the final products in which LEDs were assembled, it is recommended to check
whether the assembled LEDs are damaged by static electricity or not.
It is easy to find static-damaged LEDs by a light-on test.
*Light-on test criterion
Condition
Judgmental criterion
IF=1mA / die
No-lighting should not exist.
- ESD sensitivity of this product is 1000V (HBM, based on JEITA ED-4701/304).
Approved Checked Drawn
Symbol
Name
CL-L102-MC3L1
Drawing No
2009.03.03
Issue of first edition
Description Appro.
CITIZEN ELECTRONICS CO.,LTD.
Ref.CE-P402 03/09
Mark Date
CITIZEN [ CITIZEN ELECTRONICS CO., LTD. ]
