Preliminary Information
CAT1024, CAT1025
EMBEDDED EEPROM OPERATION
SDA when SCL is HIGH. The CAT1024/25 monitors the
SDA and SCL lines and will not respond until this
condition is met.
The CAT1024 and CAT1025 feature a 2kbit embedded
serial EEPROM that supports the I2C Bus data
transmission protocol. This Inter-Integrated Circuit Bus
protocol defines any device that sends data to the bus to
be a transmitter and any device receiving data to be a
receiver. The transfer is controlled by the Master device
which generates the serial clock and all START and
STOPconditionsforbusaccess.BoththeMasterdevice
and Slave device can operate as either transmitter or
receiver, but the Master device controls which mode is
activated.
STOP Condition
A LOW to HIGH transition of SDA when SCL is HIGH
determinestheSTOPcondition.Alloperationsmustend
with a STOP condition.
DEVICE ADDRESSING
The Master begins a transmission by sending a START
condition.TheMastersendstheaddressoftheparticular
slave device it is requesting. The four most significant
bitsofthe8-bitslaveaddressareprogrammableinmetal
and the default is 1010.
I2C Bus Protocol
The features of the I2C bus protocol are defined as
follows:
(1) Data transfer may be initiated only when the bus is
not busy.
The last bit of the slave address specifies whether a
ReadorWriteoperationistobeperformed.Whenthisbit
is set to 1, a Read operation is selected, and when set
to 0, a Write operation is selected.
(2) During a data transfer, the data line must remain
stable whenever the clock line is high. Any changes in
thedatalinewhiletheclocklineishighwillbeinterpreted
as a START or STOP condition.
After the Master sends a START condition and the slave
address byte, the CAT1024/25 monitors the bus and
responds with an acknowledge (on the SDA line) when
its address matches the transmitted slave address. The
CAT1024/25 then performs a Read or Write operation
depending on the R/W bit.
START Condition
The START Condition precedes all commands to the
device, and is defined as a HIGH to LOW transition of
Figure 3. Bus Timing
t
t
t
F
HIGH
R
t
t
LOW
LOW
SCL
t
t
HD:DAT
SU:STA
t
t
t
t
HD:STA
SU:DAT
SU:STO
SDA IN
BUF
t
t
DH
AA
SDA OUT
Figure 4. Write Cycle Timing
SCL
SDA
8TH BIT
BYTE n
ACK
t
WR
STOP
CONDITION
START
CONDITION
ADDRESS
Doc No. 3008, Rev. G
9
CATALYST [ CATALYST SEMICONDUCTOR ]
