Vout
2.5
2.6
2.7
2.8
2.9
3.0
ResistorValue
196Ω
Vout
3.1
3.2
3.3
3.4
3.5
3.6
ResistorValue
1.37k
Programming
The 6-PAK™ is programmed through the Control SIP. All
connected Power Boosters follow the Control SIP
programming.To program the 6-PAK™ forVout<3.3, connect
a resistor across theTRIM andVo pins.ForVout>3.3, resistor
is connected across TRIM and GND.
255Ω
2.80k
Open
2.32k
1.00k
332Ω
442Ω
604Ω
866Ω
649Ω
Transient Response
Operating conditions are as follows: Vin=5V, Vo=3.3V, Load change
Operating conditions are as follows: Vin=5V, Vo=3.3V, Load change
from Io=0% to Io=100%, TA=25°C, Cin=100μF, Co=0.
from Io=100% to Io=0%, TA=25°C, Cin=100μF, Co=0.
Typical Performance Curves (Unless otherwise specified, operating conditions are as follows:
Vin = 5.0V, Vo = 3.3V, Io = 6A, TA = +25°C, Cin = 100μF, Cout = 0.)
Efficiency v/s Ambient Temp.
95.00
92.00
89.00
86.00
83.00
80.00
-40
-30
-20
-10
0
10
20
30
40
50
60
Ambient Temp. (Deg. C)
NOTE: The ambient temperature is as measured at approx. 1/4” away on the back side of the unit, with the probe end at approx. center
(vertical & horizontal). For thermal performance, the unit was mounted on a 4”x4” PCB (with ground plane) & enclosed in a box so that it
operates in a controlled environment.
6-PAK 8/2001 REV F
Page 3
CANDD [ C&D TECHNOLOGIES ]
