Safety Instructions
Integrated circuits on computer boards are sensitive to static electricity. To
avoid damaging chips from electrostatic discharge, observe the following
precautions:
ꢀ
Do not remove boards or integrated circuits from their anti-static packaging
until you are ready to install them.
ꢀ
Before handling a board or integrated circuit, touch an unpainted portion of the
system unit chassis for a few seconds. This helps to discharge any static
electricity on your body.
ꢀ
ꢀ
Wear a wrist-grounding strap, available from most electronic component
stores, when handling boards and components. Fasten the ALLIGATOR clip
of the strap to the end of the shielded wire lead from a grounded object.
Please wear and connect the strap before handle the HS-4701 to ensure
harmlessly discharge any static electricity through the strap.
Please use an anti-static pad when putting down any components or parts or
tools outside the computer. You may also use an anti-static bag instead of the
pad. Please inquire from your local supplier for additional assistance in finding
the necessary anti-static gadgets.
NOTE: DO NOT TOUCH THE BOARD OR ANY OTHER SENSITIVE
COMPONENTS WITHOUT ALL NECESSARY ANTI-STATIC
PROTECTION.
BOSER [ BOSER TECHNOLOGY CO., LTD ]
