plerowTM ALE3275T2
Internally Matched LNA Module
Application Circuit
VS
+
-
Tantal or MLC (Multi Layer Ceramic)
Capacitor
C1
C2
OUT
IN
ALE
1) The tantal or MLC (Multi Layer Ceramic) capacitor is optional and for bypassing the AC noise introduced
from the DC supply. The capacitance value may be determined by customer’s DC supply status. The ca-
pacitor should be placed as close as possible to Vs pin and be connected directly to the ground plane for
the best electrical performance.
2) DC blocking capacitors are always necessarily placed at the input and output port for allowing only the
RF signal to pass and blocking the DC component in the signal. The DC blocking capacitors are includ-
ed inside the ALE module. Therefore, C1 & C2 capacitors may not be necessary, but can be added just
in case that the customer wants. The value of C1 & C2 is determined by considering the application fre-
quency.
Recommended Soldering Reflow Process
Evaluation Board Layout
Vs
20~40 sec
260 °C
Ramp-up
(3° C/sec)
IN
OUT
Ramp-down
(6° C/sec)
200 °C
150 °C
60~180 sec
Size 25x25 mm
(for ALE-T Series – 10x10 mm)
3/3
www.asb.co.kr
April 2010
ASB [ ADVANCED SEMICONDUCTOR BUSINESS INC. ]
