欢迎访问ic37.com |
会员登录 免费注册
发布采购

PPC405CR-3KC200CZ 参数 Datasheet PDF下载

PPC405CR-3KC200CZ图片预览
型号: PPC405CR-3KC200CZ
PDF下载: 下载PDF文件 查看货源
内容描述: 405CR的PowerPC嵌入式处理器 [PowerPC 405CR Embedded Processor]
分类和应用: PC
文件页数/大小: 42 页 / 820 K
品牌: AMCC [ APPLIED MICRO CIRCUITS CORPORATION ]
 浏览型号PPC405CR-3KC200CZ的Datasheet PDF文件第3页浏览型号PPC405CR-3KC200CZ的Datasheet PDF文件第4页浏览型号PPC405CR-3KC200CZ的Datasheet PDF文件第5页浏览型号PPC405CR-3KC200CZ的Datasheet PDF文件第6页浏览型号PPC405CR-3KC200CZ的Datasheet PDF文件第8页浏览型号PPC405CR-3KC200CZ的Datasheet PDF文件第9页浏览型号PPC405CR-3KC200CZ的Datasheet PDF文件第10页浏览型号PPC405CR-3KC200CZ的Datasheet PDF文件第11页  
Revision 1.02 – January 11, 2005  
PPC405CR – PowerPC 405CR Embedded Processor  
SDRAM Memory Controller  
Data Sheet  
The PPC405CR Memory Controller core provides a low latency access path to SDRAM memory. A variety of sys-  
tem memory configurations are supported. The memory controller supports up to four logical banks. Up to 256MB  
per bank are supported, up to a maximum of 1GB. Memory timings, address and bank sizes, and memory  
addressing modes are programmable.  
Features include:  
11x8 to 13x11 addressing for SDRAM (2- and 4-bank)  
32-bit memory interface support  
Programmable address compare for each bank of memory  
Industry standard 168-pin DIMMS are supported (some configurations)  
4MB to 256MB per bank  
Programmable address mapping and timing  
Auto refresh  
Page mode accesses with up to 4 open pages  
Power Management (self-refresh)  
Error Checking and Correction (ECC) support  
- Standard SEC/DED coverage  
- Aligned nibble error detect  
- Address error logging  
External Peripheral Bus Controller (EBC)  
Supports eight banks of ROM, EPROM, SRAM, Flash memory, or slave peripheral I/O  
Up to 66MHz operation  
Burst and non-burst devices  
8-, 16-, 32-bit byte-addressable data bus width support  
Programmable 2K clock time-out counter with disable for Ready  
Programmable access timing per device  
- 0–255 wait states for non-burst devices  
- 0–31 burst wait states for first access and up to 7 wait states for subsequent accesses  
- Programmable CSon, CSoff relative to address  
- Programmable OEon, WEon, WEoff (0 to 3 clock cycles) relative to CS  
Programmable address mapping  
Peripheral device pacing with external “Ready”  
External master interface  
- Write posting from external master  
- Read prefetching on PLB for external master reads  
- Bursting capable from external master  
- Allows external master access to all non-EBC PLB slaves  
- External master can control EBC slaves for own access and control  
DMA Controller  
Supports the following transfers:  
- Memory-to-memory transfers  
- Buffered peripheral to memory transfers  
AMCC  
7