ACT8840
Rev 1, 07-Feb-14
PIN DESCRIPTIONS CONT’D
PIN
NAME
DESCRIPTION
26
SW4
Switch Node for REG4.
Power Ground for REG1 and REG4. Connect GP14, GP2, GP3, and GA together at a
single point as close to the IC as possible.
27
GP14
28
29
SW1
Switch Node for REG1.
OUT1
Output Voltage Sense for REG1.
Power Input for REG1. Bypass to GP14 with a high quality ceramic capacitor placed
as close to the IC as possible.
30
31
VP1
Master Enable Input. Drive nPBIN to GA through a 50kΩ resistor to enable the IC,
drive nPBIN directly to GA to assert a Manual-Reset condition.
nPBIN
32
33
34
PWRHLD
nRSTO
nIRQ
Power hold Input.
Open-Drain Reset Output.
Open-Drain Interrupt Output.
General Purpose I/O #6. Configured as PWM LED driver output for up to 6mA current
with programmable frequency and duty cycle. See the PWM LED Drive section for
more information.
35
36
GPIO6
GPIO5
General Purpose I/O #5. Configured as PWM LED driver output for up to 6mA current
with programmable frequency and duty cycle. See the PWM LED Driver section for
more information.
37
38
OUT13
OUT7
REG13 output. Bypass it to ground with a 2.2µF capacitor.
REG7 output. Bypass it to ground with a 2.2µF capacitor.
General Purpose I/O #4. Configured as PWM LED driver output for up to 6mA current
with programmable frequency and duty cycle. See the PWM LED Driver section for
more information.
39
GPIO4
40
41
42
OUT6
INL1
REG6 output. Bypass it to ground with a 2.2µF capacitor.
Power Input for REG5, REG6, REG7.
OUT5
REG5 output. Bypass it to ground with a 2.2µF capacitor.
General Purpose I/O #3. Configured as PWM LED driver output for up to 6mA current
with programmable frequency and duty cycle. See the PWM LED Drier section for
more information.
43
44
45
GPIO3
GPIO2
GPIO1
General Purpose I/O #2. Configured as PWM LED driver output for up to 6mA current
with programmable frequency and duty cycle. See the PWM LED Drier section for
more information.
General Purpose I/O #1. Configured as PWM LED driver output for up to 6mA current
with programmable frequency and duty cycle. See the PWM LED Drier section for
more information.
46
47,48
EP
OUT3
VP3
EP
Output Voltage Sense for REG3.
Power input for REG3. Bypass to GP3 with a high quality ceramic capacitor placed as
close to the IC as possible.
Exposed Pad. Must be soldered to ground on PCB.
Innovative PowerTM
- 6 -
www.active-semi.com
Active-Semi Proprietary―For Authorized Recipients and Customers
ActivePMUTM is a trademark of Active-Semi.
I2CTM is a trademark of NXP.
Copyright © 2014 Active-Semi, Inc.
ACTIVE-SEMI [ ACTIVE-SEMI, INC ]
