ACT2813/ACT2813C
Rev 2, 19-May-15
FUNCTIONAL DESCRIPTION
ACT2813/ACT2813C is
a
complete battery
switches Q1-Q3 into HZ mode for 2 seconds before
enabling the other mode.
charging and discharging power management
solution for applications of single-cell lithium-based
backup battery pack or power bank. There is a
power path from input to output. If output voltage
drops below 4.25V, the input switch Q1 turns off
and restart in 2 seconds.
The modes are determined by HZ pin and VIN pin
as shown in the table 1. A valid VIN voltage forces
ACT2813/ACT2813C into charge mode. Boost
mode is enabled if HZ pin is pulled low and VIN is
invalid or not present. When HZ=0, if PB is pulled
low for more than 30ms, boost converter is enabled.
For ACT2813, a running boost is disabled if one of
the following conditions is met:
With the advanced ACT2813/ACT2813C
architecture, a synchronous buck/boost converter is
connected from VOUT to switching node (SW). With
the bidirectional architecture, the converter could be
configured as either buck to charge battery or boost
to discharge battery. With switching charger and
discharger, the higher charge current and higher
conversion efficiency are achieved.
1. Boost converter output current is below light
load threshold for 16 seconds.
2. Battery voltage falls below the boost cut-off
threshold.
3. After PB is released, if PB is pulled low for more
than 1.5 seconds.
Modes of Operation
ACT2813/ACT2813C has
3 operation modes:
Table 1: Mode Selection
charge mode, boost mode and high-impedance
(HZ) mode. In charge mode, the input current limit
Q1 is enabled and Q2 and Q3 operate as a buck
converter to charge battery. In boost mode, Q2 and
Q3 operate as boost converter to step battery
voltage up to +5V at VOUT, and the current limit
switch Q1 is turned off, and the reverse current from
VOUT to VIN is blocked. In HZ mode, all the
switches are turned off and the drainage current
from battery is very low. ACT2813 system operation
flow chart as shown in Figure 1 and ACT2813C
system operation flow chart as shown in Figure 2.
HZ PIN
VIN Valid
Mode
0
0
0
1
1
0
1
1
Boost
Charge
HZ
Charge
Flashlight
ACT2813C has an flashlight function. Once PB is
pressed for more than 3 seconds, the flashlight is
switched on. The driver will deliver up to 50mA
current to the flashlight. During flashlight on, if PB is
pressed for 3 seconds, flashlight will be switched
off.
Any transitions between boost mode and charge
mode go through HZ mode by turning off all the
Figure 1:
ACT2813 System Operation Flow Chart
Innovative PowerTM
- 9 -
www.active-semi.com
Copyright © 2015 Active-Semi, Inc.
ACTIVE-SEMI [ ACTIVE-SEMI, INC ]
